Insert the tab into the middle groove and tighten the green knobs. Adjust the stop to your desired measurement.
: Recommended for ripping 8-foot sheets or edge-jointing lumber up to 9 feet. It provides a single, perfectly straight reference edge that is more reliable than connecting two shorter rails.
: If you plan to use the Festool LR 32 Hole Drilling System for cabinet shelf pins, it is better to buy "holey" rails initially rather than buying standard ones and replacing them later. 2. Festool Parallel Guide System (FS-PA/FS-PA-VL) UwzCWe4JQ2VYrg4oyh4
This system allows for repeatable parallel cuts without manually measuring and marking each piece.
: When using an MFT/3 Multi-Function Table, ensure the guide rail is long enough to clear the board at both the start and end of the cut to prevent kickback. 4. Alternatives & Enhancements Festool Parallel Guides Insert the tab into the middle groove and
: The set includes a Parallel Guide (main extension) and Extensions for wider cuts. Installation : Slide the bracket into the rear groove of the guide rail.
: The standard for cross-cutting 4-foot sheets. It provides a single, perfectly straight reference edge
: Crucial for accuracy. Align the stops with a pencil mark on a fresh splinter guard cut. Use a flathead screwdriver to fine-tune the bracket position if the measurement doesn't match the scale. 3. Operational Best Practices