N_031.mp4 -

: Fully retract the boom. Turn the potentiometer counter-clockwise until it stops to reset the "zero" point.

: Verify voltage at the sensor. Expected values are roughly 3.125V (0°) and 2.5V (45°) . 3. Pressure Transducer Maintenance

: Ensure the hoist limit switch stops the winch before the hook hits the boom tip. n_031.mp4

The filename n_031.mp4 frequently appears in technical contexts related to crane systems, specifically associated with documentation for the DS 350 and EI 65 series Load Moment Indicators (LMI).

Before completing the assembly, verify these digital inputs: : Fully retract the boom

Below is a guide for the assembly and maintenance procedures typically associated with these technical standards. 🏗️ PAT/Hirschmann Crane System Guide

: Test that the system successfully disables crane functions during an overload condition. Expected values are roughly 3

: Check the angle display at 20°, 45°, and 70°. The display must be within ±0.5 degrees of the inclinometer reading.